Monterey V6-4.2L VIN 2 (2004)
MOTORCRAFT(R) CLEAR SILICONE RUBBER, TA-32, CAN NOT BE USED SINCE ITS CONSTITUENTS MAY DAMAGE THE PCM
CIRCUITRY.
9. Carefully blow off the PCM internals with filtered, dry air at 5-10 PSI (34-69 kPa) to ensure all components are dry and clean.
10. Reassemble the PCM, and bend the retaining clips back fully. Make sure a full seal is created around the top edge of the PCM - add sealant as
required. (Figure 8)