Mountaineer V8-302 5.0L VIN P EFI (1998)
Brake Rotor/Disc: Service and Repair
Brake Rotor/Disc
Front
REMOVAL
1. Remove the front disc brake caliper anchor plate.
2. Remove the front disc brake rotor.
INSTALLATION
1. Position the front disc brake rotor to the wheel hub.
-
Use Metal Brake Parts Cleaner F3AZ-19579-SA or equivalent to clean the front disc brake rotor.
2. Install the front disc brake caliper anchor plate.
Rear
REMOVAL
1. Remove the rear disc brake caliper.
NOTE: When removing the rear disc brake rotor in this procedure it is necessary to disconnect the hydraulic lines.
2. Remove the rear disc brake rotor.
NOTE: If the rear disc brake rotor binds on the rear parking brake shoe and linings, remove the adjustment hole access plug and contract the
parking brake shoe and lining.
3. Measure the rear disc brake rotor, and resurface as necessary. Replace the rear disc brake rotor if beyond specification.
CAUTION: Use a hub-mount brake lathe if necessary to machine the rear disc brake rotor
INSTALLATION
1. Follow the removal procedure in reverse order.
