Mountaineer V8-302 5.0L VIN P EFI (1998)
Transmission Position Switch/Sensor: Adjustments
Special Tools
1. If equipped, turn the air suspension switch OFF.
2. Disconnect the battery ground cable.
3. Raise the vehicle on a hoist.
4. Disconnect the manual lever shift control cable.
5. Disconnect the digital TR electrical connector.
6. CAUTION: Discard outer manual control lever shaft nut. Do not reuse. The old nut will not retain toque specification.
Remove the manual control lever.
1
Remove the nut.
2
Remove the lever.
7. Loosen the digital TR bolts.
8. NOTE: Manual shift lever must be in the neutral position
Use digital Transmission Range (TR) Sensor Alignment Tool, to align the digital TR sensor slots.