Mountaineer V8-302 5.0L VIN P EFI (1998)
4. Using a Nm (pound-inch) torque wrench, tighten the Handle.
5. NOTE: Offset the Gauge Block to obtain an accurate reading.
Rotate the Gauge Block several half turns to ensure the differential pinion bearings seat correctly, and position the Gauge Block as shown.
6. Install the special tool and the paper shipping tags.
1. Position the special tool and the paper shipping tags.
2. Install the differential bearing caps.
3. Install the bolts.
7. NOTE: Use a feeler gauge, or flat, clean drive pinion position shims as a measuring device.
NOTE: Selection of a shim that is too thick results in deep tooth contact at final assembly. Do not attempt to force the gauge or shim between the
Gauge Block and the Gauge Tube. A slight drag indicates a correct selection.