Mountaineer V8-302 5.0L VIN P EFI (1998)
![background image](/mercury/mountaineer/v8-302_5.0l_vin_p_efi/Page-1493002.png)
5. Remove the four rear driveshaft bolts and position the driveshaft out of the way.
6. NOTE: Use a drain pan when performing this step.
Remove the brake hose junction block.
1
Remove the LH rear brake tube from the brake hose junction block.
2
Remove the retaining bolt and position the brake hose junction block aside.
7. Remove the parking cable and conduit from the parking brake lever.
8. NOTE: The parking brake cables and the anti-lock speed sensor connector wiring must be rerouted at the same time.