Mountaineer V8-302 5.0L VIN P EFI (1998)
14. Use Differential Side Bearing Replacer to install the new differential bearings on the differential case .
15. Install the differential case. Position the differential case assembly, including the bearing caps, bolts and shims in the rear axle housing. Tighten
bearing caps to specifications.
16. Measure the differential case runout without the ring gear, and check the case runout again with the new differential bearings.
-
If the runout is now within the specification shown, use the new differential bearings for assembly.
-
If the runout is still excessive, the differential case is damaged and must be replaced.
INSTALLATION
1. Press a new anti-lock speed sensor ring, if removed, and the ring gear on the differential case.
-
Align the notch on the differential case flange with the notch on the anti-lock speed sensor ring.
