Mountaineer V8-302 5.0L VIN P EFI (1998)
7. Install the Gauge Tube.
1
Position the Gauge Tube.
2
Install the differential side bearing caps.
3
Install the four differential side bearing cap bolts.
8. NOTE:
-
Drive pinion bearing adjustment shims must be flat and clean.
-
A slight drag should be felt for correct shim selection. Do not attempt to force the pinion shim between the Gauge Block and the Gauge Tube.
This will minimize selection of a pinion shim thicker than required, which results in a deep tooth contact in final assembly of integral rear axle
assemblies.
Use a drive pinion bearing adjustment shim as a gauge for shim selection.
-
After the proper shim thickness has been determined, remove the Gauge Tube.
9. Use a press and Pinion Bearing Cone Replacer to press the pinion bearing until it is firmly seated on the pinion and pinion shim.