Mountaineer 2WD V6-245 4.0L VIN X SFI (2000)
Multiplex Communication Network: Testing and Inspection
Module Configuration
Inspection and Verification
1. Visually inspect for obvious signs of electrical damage.
VISUAL INSPECTION CHART
Electrical
^
Damaged wiring harness
^
Loose or corroded connectors
^
4-wheel Anti-lock Brake Control Module (4WABS)
^
Generic Electronic Module (GEM)
2. If the concern remains after inspection, connect the scan tool to the Data Link Connector (DLC) located beneath the instrument panel and select
the vehicle to be tested from the scan tool menu. If the scan tool does not communicate with the vehicle:
^
check that the program card is correctly installed.
^
check the connections to the vehicle.
^
check the ignition switch is in RUN position.
3. If the scan tool still does not communicate with the vehicle, refer to Module Communication Network (Information Bus).
4. Refer to the Symptom Chart. See: Diagnosis By Symptom
Customer Preference Items
NOTE:
^
If using the WDS, select Module Configuration and Programming, then follow the screen prompts.
^
Make sure module is listed as supporting customer preference items and supports the specific item to be configured in the Module Configuration
Index.
1. Select Service Bay Functions on the scan tool.
2. Select the module that contains the customer preference item to be programmed. Refer to the Module Configuration Index. See: Scan Tool
Testing/Module Configuration Index
3. Select Customer Preference Items on the scan tool.
4. Select Module Option Content.
5. Select the item to be enabled or disabled.
6. Enable or disable the item as necessary to reflect the customer preference.
Operational Strategy
NOTE:
^
If using the WDS, select Module Configuration and Programming, then follow the screen prompts.
^
Make sure module is listed as supporting tire size and axle ratio configuration in the Module Configuration Index.
1. Select Service Bay Functions on the scan tool.
2. Select the module that contains the Operational Strategy to be programmed. Refer to the Module Configuration Index. See: Scan Tool
Testing/Module Configuration Index
3. Select Operational Strategy.
4. Select the vehicle.
5. Select 4x4 for a 4x4 vehicle. Select 4x2 for a 4x2 vehicle.
Tire Size and Axle Ratio
NOTE:
^
If using the WDS, select Module Configuration and Programming, then follow the screen prompts.
^
Make sure module is listed as supporting tire size and axle ratio configuration in the Module Configuration Index.
1. Select Service Bay Functions on the scan tool.
2. Select the module that contains the Tire Size and Axle Ratio configuration.
3. Select Customer Preference Items.
4. Select Tire Size and Axle Ratio on the scan tool.
5. Select the vehicle.