Mountaineer 2WD V6-4.0L VIN K (2007)
Disassembly and Assembly
1. Remove the second row, 40 percent bucket seat backrest.
2. Remove the head restraint.
3. CAUTION: Use care when separating the seat back trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn
from the backrest foam pad.
Separate the backrest trim cover hook-and-loop fasteners, remove 2 rows of hog rings and invert the backrest trim cover as high as it will go.
4. NOTE:
-
The inboard and outboard head restraint sleeves are not interchangeable.
-
The head restraint sleeves incorporate an alignment tab that must face forward when installed.
Squeeze together the tip of the head restraint sleeve and pull the sleeve out of the frame tube.
5. Remove the backrest trim cover.
6. Remove the backrest foam pad from the backrest frame.