Mountaineer 2WD V6-4.0L VIN K (2007)
Accumulator HVAC: Service and Repair
Suction Accumulator
SUCTION ACCUMULATOR
Removal and Installation
NOTE: Installation of a new suction accumulator is not required when repairing the air conditioning system except when there is physical evidence of
contamination from a failed A/C compressor or damage to the suction accumulator.
All vehicles
1. Recover the refrigerant.
2. Remove the PCM.
3. Remove the low-side service port stem bracket bolt.
-
To install, tighten to 11 Nm (8 lb-ft).
4. Disconnect the A/C cycling switch electrical connector.
5. Remove the suction accumulator bolt.
-
To install, tighten to 11 Nm (8 lb-ft).