Mountaineer 2WD V6-4.0L VIN K (2007)
4.
Use the special tool, press the outboard constant velocity (CV) joint until it is loose in the hub. (Figure 2)
5.
Use a brush and apply Motorcraft(R) Silicone Brake Caliper Grease and Dielectric Compound to lubricate the rear axle halfshaft dust seal.
6.
Reverse steps 2 and 3 to install halfshaft, tire, and wheel.
Parts Block
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
081906A
2006-2008
0.5 Hr.
Explorer/Mountaineer,
2007-2008 Explorer Sport
Trac: Lubricate One Rear
Constant Velocity Outboard
Joint to Knuckle Dust Seal:
0.5 Hrs(Do Not Use With
4139A, 5968A)
081906B
2006-2008
0.9 Hr.
Explorer/Mountaineer,
2007-2008 Explorer Sport
Trac: Lubricate Both Rear
Constant Velocity Outboard
Joint to Knuckle Dust Seal:
0.9 Hrs (Do Not Use With
4139A, 5968A)
DEALER CODING
CONDITION
BASIC PART NO.
CODE
1175
14
Disclaimer
Technical Service Bulletin # 08-19-3
Date: 080929