Mountaineer 2WD V6-4.0L VIN K (2007)
Installation
All vehicles
1. Inspect the O-ring seal for damage. Install a new seal if damaged. Lubricate the O-ring seal with petroleum jelly to prevent damage to the O-ring
seal.
1
Install the OSS sensor into the transmission.
2
Tighten the OSS sensor screw.
^
Tighten to 14 Nm (10 ft. lbs.)
2. Connect the OSS sensor electrical connector.
3. Connect the HO2S connector to the transmission case.
4. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the cable end is
snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the cable to click in place. Pull back on the selector lever