Mountaineer 2WD V8-302 5.0L VIN P SFI (2000)
3. Install the driveshaft flange yoke.
1. Start a new bearing cup into the driveshaft flange yoke.
-
Check the needle bearings for correct positioning.
2. Position the driveshaft flange yoke.
3. Position the driveshaft in the U-joint tool.
4. Press the bearing cup to just below the snap ring groove.
-
Repeat for the other bearing cup.
4. Note: Use the yellow snap rings supplied in the kit to assemble the universal joint (U-joint). If difficulty is encountered with the yellow snap
rings, install the black snap rings.
Remove the driveshaft from the U-joint tool, and install the four snap rings.
5. Note: Do not strike the bearings.
Check the U-joints for freedom of movement.
-
If binding, strike the yoke with a brass or plastic hammer.
6. Install the driveshaft.