Mountaineer 2WD V8-302 5.0L VIN P SFI (2000)
5. Note: If necessary, use a pair of pliers to remove a bearing cup if it cannot be pressed out all the way.
Remove the driveshaft slip-yoke.
1. Position the driveshaft slip-yoke in the U-joint tool.
2. Press out a bearing cup.
3. Rotate the driveshaft slip-yoke.
4. Press on the spider to remove the remaining bearing cup.
5. Remove the driveshaft slip-yoke.
6. Repeat Step 5 to remove the remaining bearing cups and spider from the driveshaft.
7. Clean the yoke area at each end of the driveshaft.
Assembly
1. Note: Universal Joint Service Kits are to be installed as complete assemblies only. Do not mix components from other U-Joint Kits.
Install the bearing cup.
1. Start a new bearing cup into the driveshaft yoke.
-
Check the needle bearings for correct positioning.
2. Position the new spider in the driveshaft yoke.
3. Using the U-joint tool, press the bearing cup to just below the snap ring groove.