Mountaineer 2WD V8-302 5.0L VIN P SFI (2000)
Transmission Speed Sensor: Service and Repair
Output Shaft Speed Sensor-Rear
Removal
Warning: The electrical power supply to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension
vehicle. This can be accomplished by turning off the air suspension switch located in the rear jack storage area. Failure to do so can result in
unexpected inflation or deflation of the air springs which can result in shifting of the vehicle during these operations.
1. Raise and support vehicles.
2. Disconnect the electrical connector.
3. Remove the rear output shaft speed sensor wires from the electrical shift motor connector.
1. Remove the connector interlock.
2. Remove the wires.
-
Use the proper electrical connector pin remover.
4. Remove the bolt and the sensor.
Installation