Mountaineer 2WD V8-4.6L (2010)
Parking Assist Control Module: Service and Repair
Parking Aid Module (PAM) - Mountaineer
Removal and Installation
1. NOTE: Module configuration is only required if a new Parking Aid Module (PAM) is being installed.
Upload the PAM configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in
Information Bus. See: Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and
Relearning/Programmable Module Installation (PMI)
2. Remove the RH quarter trim panel.
3. If replacing the parking aid speaker only, proceed as follows:
-
Disconnect the parking aid speaker electrical connector.
-
Remove the parking aid speaker push pins.
-
Remove the parking aid speaker.
4. If replacing the Parking Aid Module (PAM), proceed as follows:
-
Disconnect the PAM and parking aid speaker electrical connectors.
-
Remove the screw.
-
Remove the PAM.
5. To install, reverse the removal procedure.
-
Download the configuration information to the PAM. For additional information, refer to PMI in Information Bus. See: Powertrain
Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning/Programmable Module
Installation (PMI)