Mountaineer 2WD V8-4.6L (2010)
6. Install the reverse servo assembly. Tighten the reverse servo assembly screws in 2 stages, in the sequence shown.
-
Stage 1: Tighten to 5 Nm (44 lb-in).
-
Stage 2: Tighten to 11 Nm (97 lb-in).
7. Install new O-ring seals on the transmission control solenoid body connector. Lubricate the O-ring seals with transmission fluid.
8. NOTICE: Inspect the transmission case bore to make sure it is free of foreign material and not damaged. If damaged, a transmission leak
may occur.
Install the transmission control solenoid body. Tighten the transmission control solenoid body screws in the sequence shown.
-
Tighten to 8 Nm (71 lb-in).
9. NOTICE: Damage may occur to transmission fluid filter seals if they are not lubricated with transmission fluid.
NOTE: Make sure that the transmission fluid filter seals are correctly seated on the transmission fluid filter.
Lubricate the transmission fluid filter seals and install the transmission fluid filter. Tighten the transmission fluid filter screws.
-
Tighten to 10 Nm (89 lb-in).
10. NOTE: The transmission fluid pan gasket is reusable. Clean and inspect for damage. If not damaged, the transmission fluid pan gasket should be
