Mountaineer 2WD V8-4.6L (2010)
4.6L engine
5. Index-mark the front U-joint flange to the transmission output flange.
6. NOTE: If new flange bolts are not available and the originals are not damaged, they can be reused if the threads are coated with threadlock and
sealer.
Remove and discard the 4 driveshaft flange bolts from the transmission output shaft flange.
-
To install, tighten the 4 new bolts to 112 Nm (83 lb-ft).
All vehicles
7. NOTE: If new flange bolts are not available and the originals are not damaged, they can be reused if the threads are coated with threadlock and
sealer.
Remove and discard the 4 driveshaft flange bolts from the drive pinion flange.
-
To install, tighten the 4 new bolts to 112 Nm (83 lb-ft).
8. NOTE: Never hammer on the driveshaft, or any of its components, to disconnect the driveshaft flange from the differential pinion flange.
Using a suitable tool, pry only in the area shown to separate the driveshaft flange and the differential pinion or transmission output flange.