Mountaineer 2WD V8-4.6L SOHC VIN W (2003)
7.
Verify applique to top rubber mask alignment quickly as you have eight to ten (8-10) minutes working time (Figure 2). Open lift glass. Using
extremely light pressure apply two (2) small clamps on the top corner ends to hold it in place.
NOTE
EXCESSIVE CLAMP PRESSURE CAN CAUSE DEPRESSION IN THE APPLIQUE. BE SURE THAT THE APPLIQUE IS CENTERED, WITH
AN EVEN GAP ON EACH SIDE.
8.
Apply tape, 2" wide X 6" in length every 4 inches vertically, starting on the bottom and then the top edge.
9.
Remove clamps on edge and replace with masking tape immediately after Step 8.
10.
Apply the 2" wide tape the full length horizontally of top and bottom, wrapping around backside.
11. Allow a minimum of forty five (45) minutes at 21°C (70° F) dry time and remove tape.
12.
Install new emblems.
Parts Block
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
OPERATION
DESCRIPTION
TIME
052402A
2002-2005 Explorer and
1.3 Hrs.
2003-2005 Aviator:
Replace Liftgate Glass
Applique
052402A
2002-2005 Mountaineer:
1.4 Hrs.
Replace Liftgate Glass
Applique
052402B
2002-2005
1.2 Hrs.
Explorer/Mountaineer and
2003-2005 Aviator:
Additional Time To Paint
Applique. To Be Used With
Operation A (Includes
Time For P101 Basic
Paint)