Mountaineer 2WD V8-4.6L SOHC VIN W (2003)
If a restraint system diagnostic tool is installed at the safety canopy electrical connector, a low resistance fault will be generated by the RCM.
Vehicles with safety canopies
15. Remove the RH C-pillar trim panel.
1
Pull out and release the retaining clips.
2
Pull out and release the retainer.
3
Lower the door opening weatherstrip, slide the C-pillar trim panel up, releasing the retainers and remove the C-pillar trim panel.
16. Disconnect the RH safety canopy electrical connector.
17. Attach the restraint system diagnostic tool to the vehicle harness side of the RH safety canopy electrical connector.
18. Remove the LH C-pillar trim panel.
1
Pull out and release the retaining clips.