Mountaineer 2WD V8-4.6L SOHC VIN W (2003)
Item 6: LH Valve Cover Removal Note
1. Disconnect the Evaporative Emissions (EVAP) canister purge solenoid electrical connector.
2. Remove the EVAP canister purge solenoid bracket bolt and position the solenoid aside.
3. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools
cause scratches and gouges with make leak paths. Use a plastic scraping tool to remove all traces of old sealant.
Clean and inspect the valve cover mating surface of the cylinder head with metal surface cleaner.
4. Inspect the valve cover gasket. If the gasket is damaged, remove and discard the gasket. Clean the valve cover gasket groove with soap and water
or a suitable solvent.
Items 6: LH Valve Cover Installation Note
1. If a new gasket is being installed, apply instant adhesive completely around the gasket groove in the valve cover.