Mountaineer 2WD V8-4.6L VIN 8 (2006)
Ignition Coil: Service and Repair
IGNITION COIL-ON-PLUG
Exploded View
Removal and Installation
1. Disconnect the battery ground cable.
2. Disconnect the ignition coil electrical connectors.
3. Remove the ignition coil bolts.
-
To install, tighten to 5 Nm (44 lb-in).
4. NOTE: When removing the ignition coils, a slight twisting motion will break the seal and ease removal.
Remove the ignition coils.
5. To install, reverse the removal procedure.
-
Apply a light film of brake caliper grease to the inside of the coil boots before installation.