Mountaineer 2WD V8-4.6L VIN 8 (2006)
7. Remove the first row of hog rings.
8. Detach the hook and loop strips and invert the seat backrest trim cover up enough to expose the side air bag.
9. NOTE: Note the position and the routing of the side air bag module wiring harness for installation.
Detach the side air bag wiring harness retainers from the seat backrest frame.
10. Position out the seat backrest foam pad.
11. Remove the 2 bolts and the side air bag module.
Installation
WARNING:
-
Inspect the mounting surfaces of the side air bag module and the seat back frame mounting bracket for any foreign objects before
installing the side air bag module. If any foreign objects are found, remove them. Failure to do so may result in personal injury, in the
event of an air bag deployment.
-
Before installing the side air bag module, check it for damage and foreign objects. If the air bag module is damaged, replace it. If any
foreign objects are found, remove them. Failure to do so may result in personal injury, in the event of an air bag deployment.
-
Inspect the side air bag cavity in the seat back pad for any foreign objects. If any foreign objects are found, remove them. Failure to do so
may result in personal injury in the event of an air bag deployment.
-
If the air bag cover has separated or the air bag material has been exposed, install a new side air bag module. Do not attempt to repair
the air bag module. Failure to do so may result in personal injury in the event of an air bag deployment.
CAUTION: Make sure the side air bag module wiring harness is not pinched between the side air bag module and the backrest frame.
All seats
