Mountaineer AWD V6-4.0L (2008)
Passenger Seat Cushion (Part 2)
Special Tool(s)
Special Tool(s)
Removal and Installation
WARNING: Never probe the electrical connectors on air bag, safety canopy or side air curtain modules. Failure to follow this instruction may
result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Driver shown, passenger similar.
All seats
1. Remove the front seat.
2. Remove the cushion side shield in the following sequence.
1
If equipped, remove the clip and manual recline handle.
2
If equipped, pull and remove the manual lumbar control knob.
-
Make sure the lumbar is completely relaxed before removing the handle.
3
Remove the scrivet.
4
Release the cushion side shield front clip.
5
From under the cushion side shield, release the 3 hook retainers.
6
Pull out on the cushion side shield at the back and release the pin-type retainer.