Mountaineer AWD V6-4.0L (2008)
Electronic Brake Control Module: Service and Repair
Anti-Lock Brake System (ABS) Module
Removal and Installation
CAUTION: Electronic modules are sensitive to electrical charges. The anti-lock brake system (ABS) module can be damaged if exposed to
these charges.
NOTE: When installing a new ABS module, it must be configured (using vehicle as-built data) and calibrated. Follow the scan tool directions for the
calibration procedures. For module configuration, refer to Programmable Module Installation in Information Bus (Module Configuration).
1. Remove the hydraulic control unit (HCU).
2. Remove the 4 screws and the ABS module.
^
To install, tighten to 2 Nm (18 lb-in).
3. CAUTION: Make sure that the anti-lock brake system (ABS) module is properly seated to the hydraulic control unit (HCU) and that the
torque of the ABS module screws is correct, or damage to the components can occur.
To install, reverse the removal procedure.