Mountaineer AWD V6-4.0L (2008)
14. Disconnect the fan clutch electrical connector.
15. Remove the fan clutch wiring harness bracket bolt.
^
To install, tighten to 7 Nm (62 lb-in).
16. CAUTION: Do not side load the cooling fan clutch coil or the cooling fan clutch coil may be damaged.
NOTE: 4.6L (3V) engine shown, 4.0L SOHC engine similar.
Using the special tools, remove the cooling fan.
^
To install, tighten to 55 Nm (41 lb-ft).
17. Remove the bolts and the lower fan shroud.
18. Detach the A/C tube from the retainer on the radiator support bracket.
19. Remove the radiator support bracket-to-radiator support bracket bolts.
^
To install, tighten to 15 Nm (11 lb-ft).
20. Remove the radiator top seal.
21. NOTE: Do not remove the A/C condenser seals.
Deflect the A/C condenser seals and remove the A/C condenser-to-radiator support bracket bolts.
^
Position the A/C condenser aside.
^
To install, tighten to 12 Nm (9 lb-ft).