Mountaineer AWD V6-4.0L (2008)
Removal
Both sides
1. Remove the camshaft roller followers.
2. Remove the nut and position the wiring harness bracket aside.
3. NOTE: You must carry out the RH and LH camshaft timing procedure when either camshaft is serviced.
Rotate the crankshaft clockwise to position the No. 1 cylinder at top dead center (TDC).
4. CAUTION: Do not rotate the engine counterclockwise. Rotating the engine counterclockwise will result in incorrect timing of the engine.
NOTE: The special tool must be installed on the damper and should contact the engine block. This positions the piston at TDC.