Mountaineer AWD V6-4.0L (2008)
NOTE: After installing the bolts, check the camshaft for free rotation.
Position the camshaft bearing caps and the bolts.
^
Tighten the bolts in the sequence shown in 2 stages.
^
Stage 1: Tighten to 6 Nm (53 lb-in).
^
Stage 2: Tighten to 16 Nm (12 lb-ft).
RH side
3. CAUTION: The camshaft gear must turn freely on the camshaft. DO NOT tighten the bolt at this time. Tightening the bolt may result in
incorrect engine timing.
Install the camshaft sprocket and loosely install the bolt.
LH side
4. CAUTION: The camshaft gear must turn freely on the camshaft. DO NOT tighten the bolt at this time. Tightening the bolt may result in
incorrect engine timing.
Install the camshaft sprocket and loosely install the bolt.
Both sides
5. Time the camshafts.