Mountaineer AWD V6-4.0L (2008)
Removal and Installation
All vehicles
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Disconnect the battery ground cable. For additional information, refer to Battery.
3. Remove the weatherstrip.
4. Remove the bolt and position the power steering fluid reservoir aside.
^
To install, tighten to 7 Nm (62 lb-in).
5. CAUTION: Allow the engine to cool before removing the coolant expansion tank. The radiator draws coolant from the coolant expansion
tank as the engine cools. If the coolant expansion tank is removed before the engine cools, the radiator will draw air into the system,
resulting in possible engine damage.
Disconnect the coolant overflow hose. Remove the bolts and the coolant expansion tank.
^
To install, tighten to 7 Nm (62 lb-in).