Mountaineer AWD V6-4.0L (2008)
7. Remove the condenser-to-evaporator line bracket nut.
-
To install, tighten to 7 Nm (62 lb-in).
8. Remove the condenser outlet fitting nut and disconnect the fitting.
-
Discard the O-ring seal.
-
To install, tighten to 8 Nm (71 lb-in).
9. Disconnect the auxiliary evaporator inlet line fitting (if equipped).
-
Discard the O-ring seals.
10. Remove the front portion of the condenser-to-evaporator line.
11. Remove the A/C line bracket nut at the dash panel and detach the bracket.
-
To install, tighten to 6 Nm (53 lb-in).
12. Disconnect the evaporator inlet fitting.
-
Discard the O-ring seals.
13. Remove the rear portion of the condenser-to-evaporator line.
14. To install, reverse the removal procedure.
-
Install new O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
15. Evacuate, leak test and charge the refrigerant system.
Auxiliary Evaporator Outlet and Inlet Line - Front
AUXILIARY EVAPORATOR OUTLET AND INLET LINE - FRONT
