Mountaineer AWD V6-4.0L (2008)
Steering Column Multifunction Switch (Part 2)
Removal and Installation
CAUTION: Do not remove the ignition lock cylinder and the ignition switch at the same time or damage to the column may result.
1. Disconnect the battery ground cable.
2. Remove the 2 screws and the steering column opening cover.
3. Remove the 3 screws and the upper and lower steering column shrouds.
4. Disconnect the multi-function switch electrical connector.
5. Remove the 2 multi-function switch screws and the multi-function switch.
^
To install, tighten to 3 Nm (27 lb-inch).
6. To install, reverse the removal procedure.
