Mountaineer AWD V6-4.0L (2008)
7. Route the wheel stud through the access hole and discard the wheel stud.
Installation
1. Position the new wheel stud aligning the serrations in the wheel hub made by the original wheel stud.
2. CAUTION: Do not use power tools to install the wheel stud. The serrations on the stud can be stripped.
NOTE: Do not use the wheel nut that came with the vehicle.
Place flat washers over the outside end of the wheel stud and thread a standard wheel nut with the flat side against the washers. Tighten the wheel
nut until the wheel stud seats against the back side of the wheel extension.
^
Discard the wheel nut and washers.
3. CAUTION: A plug must be installed in place of the knockout to prevent contamination to the parking brake shoe assemblies.
Install a plug into the access hole on the brake shield.
4. Install the parking brake shoe adjuster and spring.
5. Install the brake disc.
6. Position the brake caliper and install the bolts.
^
Tighten to 32 Nm (24 lb-ft).
