Mountaineer AWD V6-4.0L (2008)
8. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the selector lever
cable end is snapped onto the ball stud. Press the selector lever cable into the selector lever cable bracket and listen for the selector lever cable to
click in place. Pull back on the selector lever cable to make sure that it is locked into the selector lever cable bracket. Also make sure that the
selector lever cable end is correctly installed onto the ball stud. Pull back on the selector lever cable end to make sure that the selector lever cable
end is correctly installed.
Carry out the following adjustments on the selector lever cable end:
1
Make sure that the selector lever cable end slides forward and backward.
2
Connect the selector lever cable end onto the manual control lever.
3
Lock the selector lever cable end into place by pressing the lock tab down.
9. NOTE: If the selector lever cable shield is loose on the selector lever cable, install a new selector lever cable shield.
Install and secure the selector lever cable shield.
10. Verify that the engine will start in PARK and NEUTRAL. Verify that the reverse lamps will illuminate in the REVERSE position. If not, check the
adjustment of the transmission range (TR) sensor.