Mountaineer AWD V6-4.0L (2008)
Drive/Propeller Shaft: Service and Repair
Driveshaft - Rear, Two-Piece
Driveshaft - Rear, Two-Piece, Four Wheel Drive (4WD)
Driveshaft - Rear, Two-Piece, Four Wheel Drive (4WD)
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the 2 nuts from the driveshaft center bearing bracket.
^
To install, tighten to 55 Nm (41 lb-ft).
