Mountaineer AWD V6-4.0L (2008)
Removal and Installation
Both halfshafts
1. CAUTION: Do not loosen the front axle wheel end nut until after the wheel and tire assembly are removed from the vehicle. Wheel
bearing damage will occur if the wheel bearing is unloaded with the weight of the vehicle applied.
With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the front wheel and tire.
3. Remove and discard the front axle wheel end nut.
^
To install, tighten to 200 Nm (148 lb-ft).
4. NOTE: To prevent damage to the brake hose, do not allow the disc brake caliper to hang suspended from the hose.