Mountaineer AWD V6-4.0L (2008)
3. NOTE: If new driveshaft yoke bolts are not available, coat the threads of the original bolts with Threadlock(R) and sealer.
Remove the 4 driveshaft yoke bolts.
^
To install, tighten to 112 Nm (83 lb-ft) evenly in a cross pattern.
4. CAUTION: The driveshaft flange fits tightly on the rear axle pinion flange pilot. Never hammer on the driveshaft or any of its
components to disconnect the driveshaft flange from the pinion flange. Pry only in the area shown, with a suitable tool, to disconnect the
driveshaft flange from the pinion flange or damage to the components can occur.
Using a suitable tool as shown, disconnect the driveshaft flange from the rear axle pinion flange.
5. Position the driveshaft aside and support with mechanic's wire.