Mountaineer AWD V8-4.6L (2010)
![background image](/mercury/mountaineer_awd/v8-4.6l/Page-2373022.png)
Disassembly and Assembly
1. Remove the second row 60 percent seat of the 60/40 bench seat. For additional information, refer to Seat - Second Row, Sport Trac or Seat -
Second Row, Explorer, 60/40 Bench .
2. Remove the second row 60 percent bench seat backrest. For additional information, refer to Seat Backrest - Second Row, 60 Percent, Bench See:
Seat Back/Service and Repair/Removal and Replacement/Rear Seat/Seat Backrest - Second Row, 60 Percent, Bench.
3. Remove the inboard upper pivot latch bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
4. NOTICE: Use care when separating the cushion trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the
cushion foam pad.
Release the J-clips, separate the hook-and-loop fasteners, remove the hog rings and the cushion trim cover.
5. Remove the cushion foam pad.
6. Remove 2 cushion pad supports.
7. To assemble, reverse the disassembly procedure.
Seat Cushion - Second Row, Bucket
Seat Cushion - Second Row, Bucket