Mountaineer AWD V8-4.6L (2010)
-
Brake shift interlock actuator
-
ABS module
-
PCM
-
SJB
PINPOINT TEST J: THE STOPLAMPS ARE ON CONTINUOUSLY
NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the
connector.
-------------------------------------------------
J1 DETERMINE IF ALL THE STOPLAMPS ARE ILLUMINATED
-
Ignition OFF.
-
Observe the stoplamps with the brake pedal released.
-
Are all of the stoplamps illuminated?
Yes
GO to J2.
No
GO to J9.
-------------------------------------------------
J2 CHECK THE STOPLAMP SWITCH
-
Disconnect: Stoplamp Switch C278.
-
Do the stoplamps continue to illuminate?
Yes
GO to J3.
No
INSTALL a new stoplamp switch. REFER to Stoplamp Switch See: Brake Light Switch/Service and Repair. CLEAR the DTCs. REPEAT the self-test.
-------------------------------------------------
J3 CHECK THE BRAKE SHIFT INTERLOCK ACTUATOR
-
Disconnect: Brake Shift Interlock Actuator C2008.
-
Do the stoplamps continue to illuminate?
Yes
GO to J4.
No
INSTALL a new brake shift interlock actuator. REFER to Automatic Transmission/Transaxle. CLEAR the DTCs. REPEAT the self-test.
-------------------------------------------------
J4 CHECK THE ABS MODULE
-
Disconnect: ABS Module C155.
-
Do the stoplamps continue to illuminate?
Yes
If equipped with a TBC module, GO to J5.
If not equipped with a TBC module, GO to J6.
No