Mountaineer AWD V8-4.6L VIN 8 (2006)
8. Remove and discard the lower arm forward nut and bolt.
^
To install, tighten to 400 Nm (296 ft. lbs.) at curb height.
9. Remove the lower arm rearward nut and bolt and the lower control arm.
^
Discard the nut and bolt.
^
To install, tighten to 200 Nm (148 ft. lbs.) at curb height.
10. CAUTION: Before tightening any 1uspension bushing fasteners, use a suitable back to raise the suspension until the distance between the center
of the hub and the lip of the fender is equal to the measurement taken in Step 1 (curb height).
To install, reverse the removal procedure.
^
Check and, if necessary, align the front end.
Upper Arm
Upper Arm
Special Tool
Special Tool(s)