Mountaineer AWD V8-4.6L VIN 8 (2006)
3. Slide the shift lever lower trim cover downward.
4. Remove the set screw and remove the shifter knob while routing the transmission control switch harness out of the selector lever housing.
Installation
1. CAUTION: Do not overtighten the set screw or damage to the shift lever knob may occur.
Install the shifter knob and set screw while routing the transmission control switch harness through the selector lever housing.
^
Tighten to 3 Nm (27 lb-in).
2. Slide the shift lever lower trim cover upward.