Mountaineer AWD V8-4.6L VIN 8 (2006)
Drive/Propeller Shaft: Service and Repair
Driveshaft - Rear
Driveshaft - Rear 4x4
Material
Material
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. If equipped, remove the skid plate.
3. Index-mark the driveshaft flange to the transfer case rear output flange to maintain driveshaft balance.
4. Index-mark the driveshaft flange to the pinion flange to maintain driveshaft balance.
5. Remove and discard the driveshaft flange bolts.
^
To install, tighten to 112 Nm (83 ft. lbs.).