Mystique L4-122 2.0L DOHC VIN 3 SFI (1995)
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Pinpoint Tests/H - Fuel Control/H5 - Cylinder Balance
Diagnostic Test Mode: MFI Engines
DTC 211
Profile ignition pickup circuit failure.
KOEO Memory Code ............................................................................................................................................................................... Go to NC1
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Pinpoint Tests/NC - Ignition Diagnostic Monitor -- High
Data Rate/NC1 - Continuous Code 211: Erratic Ignition
DTC 212
Loss of ignition diagnostic monitor input to powertrain control module or spark output circuit grounded.
KOEO Memory Code ............................................................................................................................................................................... Go to NC3
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Pinpoint Tests/NC - Ignition Diagnostic Monitor -- High
Data Rate/NC3 - Continuous Code 212: Check For Other EEC Codes
DTC 213
Spark output circuit open.
KOER Hard Code ..................................................................................................................................................................................... Go to PC1
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Pinpoint Tests/PC - Spark Timing Check -- High Data
Rate/PC1 - Check Power to PCM
DTC 214
Cylinder identification circuit failure.
KOEO Memory Code ............................................................................................................................................................................... Go to DR1
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Pinpoint Tests/DR - Cylinder Identification (CID)
Sensor/DR1 - Will Engine Start
DTC 215
Powertrain control module detected coil 1 primary circuit failure.
KOEO Memory Code - Go to Ignition System / Testing and Inspection.
DTC 216
Powertrain control module detected coil 2 primary circuit failure.
KOEO Memory Code - Go to Ignition System / Testing and Inspection.
DTC 217
Powertrain control module detected coil 3 primary circuit failure.
KOEO Memory Code - Go to Ignition System / Testing and Inspection.
DTC 218
Loss of ignition diagnostic monitor signal-left side.
KOEO Memory Code - Go to Ignition System / Testing and Inspection.
DTC 219
Spark timing defaulted to 10 degrees, spark output circuit open.
KOEO Memory Code - Go to Ignition System / Testing and Inspection.
