Mystique V6-153 2.5L DOHC VIN L SFI (1999)
Brake Bleeding: Service and Repair
Pressure Bleeding
CAUTION: Make sure that the vehicle is support on a level surface.
CAUTION: If brake fluid is spilt on the paint work, the affected area must be immediately washed down with cold water.
NOTE: The system consists of separate circuits for each front and diagonally opposite rear wheel. Each front to rear circuit and each wheel circuit can
be bled individually of each other.
NOTE: If the ABS hydraulic unit needs to be purged, first bleed the system conventionally and then run the bleed option on the NGS diagnostic
menu following the instructions given.
1. CAUTION: Make sure that the filler cap does not become contaminated.
Remove the reservoir filler cap.
1
Disconnect the low fluid level warning indicator switch electrical connector.
2
Remove the cap.
2. Fill the fluid reservoir to the MAX mark.
3. CAUTION: The manufacturers instructions must be strictly adhered to.
Pressure bleed the system using a suitable pressure bleeder following the equipment manufacturers instructions.
4. Fill the fluid reservoir to the MAX mark.
