Mystique V6-153 2.5L DOHC VIN L SFI (1999)
3.
Remove the accelerator cable end from the throttle body lever and remove the accelerator cable from the bracket. See Figure 1.
4.
Disconnect the accelerator cable from the end of the accelerator pedal. See Figure 2.
NOTE:
The dash panel grommet is part of the accelerator cable assembly. After the cable housing is pulled out of the grommet, be sure the grommet is
disengaged from the dash panel before attempting to fully remove the cable from the dash panel.
5.
From the engine compartment, firmly pull the accelerator cable through the dash panel. If the grommet does not disengage from the dash panel,
use a screwdriver from inside of the vehicle to push it out. See Figure 3.
6.
Install the new accelerator cable in the dash panel.
^
From inside the engine compartment, feed the accelerator cable through the cable hole in the dash panel.
^
From inside the passenger compartment, pull the accelerator cable through the dash panel until the rubber grommet is fully seated in the dash
panel.
^
Then, from inside the engine compartment, check to make sure the cable housing end is fully seated inside the grommet.
7.
Connect the accelerator cable to the accelerator pedal.
