mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Powertrain Management > < Exhaust - Popping/Pinging Noise On Engine Shutdown
Page 1
background image

Exhaust Resonator: Customer Interest
Exhaust - Popping/Pinging Noise On Engine Shutdown

Article No. 86-19-6

EXHAUST - RESONATOR - POPPING/PINGING NOISE ON ENGINE SHUTDOWN - 3.0L

FORD 1986 TAURUS

LINCOLN-MERCURY 1986 SABLE

Figure 3

Exhaust system popping/pinging noise after engine shutdown can be reduced by installing a new resonator and inlet pipe, part number E6DZ-5A289-B.
Use the following procedure and Figure 3.
1.

Remove the two bolts holding the resonator and pipe assembly to the converter.

2.

Remove exhaust gasket, part number E6DZ- 5E241-A. Inspect and if not damaged, reuse.

3.

Loosen U-bolt holding resonator to muffler assembly. Heat pipe if required to aid in removal of resonator assembly.

4.

With resonator assembly free of vehicle, remove bolt retainers and discard. All other bolts, springs and nuts are reusable if not damaged.

5.

Install new resonator assembly using either new or undamaged exhaust gasket. The spring loaded bolts holding the exhaust gasket to converter are
to be tightened to 28-45 N-m (21-33 ft.lbs.). U-bolt nuts should be tightened to 34-47 N-m (25-35 ft. lbs.).

6.

Start vehicle and inspect for any exhaust leaks prior to delivery to customer.

PART NUMBER

PART NAME

CLASS

E6DZ-5A289-B

Resonator and Inlet Pipe

C

Assembly

E6DZ-5E241-A

Gasket

B

OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual.
OPERATION: SP5289A86
TIME:

0.5 Hr. DLR. CODING: Basic Part No. 5A289 - Code: 56

Powertrain Management > < Exhaust - Popping/Pinging Noise On Engine Shutdown