Sable V6-182 3.0L (1986)
13.
Pivot glove compartment assembly by depressing side of glove compartment tray.
14.
Using glove compartment and steering column openings for access, disconnect electrical connections, vacuum hoses, heater and A/C (if equipped)
control cables and radio antenna cable.
15.
Remove two lower instrument panel-to-cowl side retaining screws both both sides of instrument panel.
16.
Disconnect under hood connectors from main wiring harness. Disengage main harness rubber grommet from dash panel, then feed wiring harness
and its connector halves into instrument panel area.
17.
Remove one (1) bolt attaching instrument panel to floor brace above LH side of tunnel.
18.
Remove two (2) lower instrument panel-to-cowl side retaining screws at both LH and RH side
19.
Snap out left and right front speaker opening covers and defroster grill, then remove three upper instrument panel attaching screws.
20.
Remove instrument panel and lay it on front seat.
REMOVE HEATER CASE
21.
Remove instrument panel to heater case shake brace attaching screw, then the instrument panel shake brace.
22.
Remove floor register or rear seat adapter to heater case attaching bolts, then the floor register.
Heater Case Assembly