Sable V6-183 3.0L DOHC VIN S MFI (1997)
INSTALLATION
1. Position the front seat tracks to the front seat cushion frame and spring.
2. Secure the front seat back covers to the front seat cushion frame and spring using the four retaining bolts. Tighten the bolts to 12-24 Nm (107-212
Lb-In).
3. Install front seat back latch and seat back-to-latch screws to front seat track. Tighten to 44-60 Nm (33-44 Lb-Ft).
4. Transfer motor harness to new front seat track.
5. Connect front seat adjusting motor drive tube.
6. Install front seat cushion side shield to the front seat track.
7. Connect the seat regulator control switch to seat regulator motor harness connector.
8. Install front safety belt buckle end to front seat track.
9. Position the seat and track assembly in vehicle.
10. Lift seat and track assembly high enough to permit the connection of the harness connectors, then connect wires.
11. Install the seat track-to-front floor pan retaining nuts and washers and/or bolts. Tighten the bolts to 19-26 Nm (14-19 Lb-Ft), inboard nut to 68-92
Nm (50-67 Lb-Ft) and outboard nut to 19-26 Nm (14-19 Lb-Ft).
12. Install four front seat track to floor insulators.
13. Connect battery ground cable.
14. Check front seat tracks for proper operation.
