mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

A/C - R134a Tracer Dye and Three O Ring Spring Couplers|Page 11102 > < Diagram Information and Instructions|Page 11096
Page 1
background image

A/C Coupler O-ring: Technical Service Bulletins
A/C - R134a Tracer Dye and Three O Ring Spring Couplers

Article No. 
97-3-5

02/03/97

AIR CONDITIONING - R-134A TRACER DYE INSTALLED IN A/C SYSTEM AND THREE 0-RING SPRING LOCK COUPLERS - SERVICE TIP

FORD: 
1996-97 CONTOUR, CROWN VICTORIA, ESCORT, MUSTANG, PROBE, TAURUS, THUNDERBIRD

LINCOLN-MERCURY: 
1996-97 CONTINENTAL, COUGAR, GRAND MARQUIS, MARK VIII, MYSTIQUE, SABLE, TOWN CAR, TRACER

LIGHT TRUCK: 
1996 BRONCO
1996-97 AEROSTAR, ECONOLINE, EXPLORER, F-150-350 SERIES,
RANGER, WINDSTAR
1997 EXPEDITION, MOUNTAINEER

This TSB article is being republished in its entirety to update the text.

ISSUE: 
Ford Motor Company now produces new vehicles with R-134a fluorescent tracer dye incorporated into the A/C system and spring lock couplings which
contain three (3) O-rings.

ACTION:
Leak checking can be performed with the use of a Rotunda UV Lamp (112-R0021) and is an acceptable alternative to using an electronic leak detector.

Ford Motor Company has begun implementation of spring lock couplings with three (3) O-rings which provide an improved seal. Field and laboratory
tests have shown a 40% improvement in sealing capability and durable life.

Through field and fleet testing and analysis, it is apparent that lubricating oil used in vehicle assembly processes is easily misdiagnosed as a refrigerant
leak. The presence of oil at connections is not necessarily an indication of a leaking connection. If oil at a fitting is due to a leak, fluorescent tracer dye
will be present at the location. Any oil escaping from the A/C hoses will contain dye.

When checking for leaks, be sure to scan all components, fittings and lines of the A/C system with the UV lamp. The exact location of the leak or leaks
can be pinpointed by the bright yellow-green glow of the tracer dye. Since more than one leak may exist in the system, always inspect each component.

The best leak detection results will be achieved in conditions of low ambient light. In areas that cannot be reached by the UV lamp: (1) use a technician's
mirror or (2) use a non-fluorescent shop towel, wipe the suspected area, and then check the towel with the UV lamp for traces of the dye.

After the leak is repaired, the traces of dye can be removed from the previously leaking areas by using any general purpose oil solvent.

Verify the repair by operating the A/C system for a short while and reinspecting the system with the UV lamp.

NOTE

BEGINNING WITH VEHICLES PRODUCED IN MAY 1996, THE TRACER DYE'S FLUORESCENT LIFESPAN IS THE LIFE OF THE
VEHICLE. VEHICLES PRODUCED BEFORE MAY 1996 CONTAIN A TRACER DYE WITH A LIFESPAN OF ROUGHLY 500 HOURS OF
NC SYSTEM USE, AFTER WHICH TIME ANOTHER INFUSION OF DYE WOULD BE REQUIRED. REFER TO TSB 94-26-6 AND 95-21-4
IF ADDITIONAL TRACER DYE OR INFORMATION IS REQUIRED.

OTHER APPLICABLE ARTICLES: 94-23-10, 94-26-6, 95-21-4, 96-15-6

SUPERSEDES: 95-21-4

WARRANTY STATUS: INFORMATION ONLY 

OASIS CODES: 208000, 208200, 208999

A/C - R134a Tracer Dye and Three O Ring Spring Couplers|Page 11102 > < Diagram Information and Instructions|Page 11096