Sable V6-183 3.0L DOHC VIN S MFI (1997)
Position A/C evaporator housing assembly against the dash panel and cowl top panel at air inlet opening. Install screws and nut retaining support
bracket to cowl top panel. Tighten to 2.7-6.8 Nm (24-60 lb-in).
2. Install three nuts in engine compartment retaining A/C evaporator housing to cowl panel. Tighten to 4.1-9.5 Nm (37-84 lb-in).
3. Install heater outlet floor duct.
4. Install instrument panel, please refer to Body and Frame/Interior Trim/Dash Board/Service and Repair/ See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Service and Repair
5. CAUTION: Make sure correct type O-ring seals are installed on A/C fittings.
Remove caps then connect condenser to evaporator tube and suction accumulator/drier inlet tube to A/C evaporator core.
6. Remove caps then connect heater water hoses to heater core.
7. Connect black vacuum supply hose to A/C vacuum check valve in engine compartment.
8. Fill radiator to correct level with previously removed coolant or specified mixture of coolant and water.
9. Connect battery ground cable.
10. Leak-test, evacuate and charge A/C refrigerant system, please refer to Heating and Air Conditioning/Service and Repair/ See: Service and Repair
11. Check system for proper operation.