Sable V6-183 3.0L DOHC VIN S MFI (1997)
19.
Remove and discard fuel sender.
20.
Remove and discard fuel sender seal.
21.
Lubricate and install new fuel sender seal.
22.
Install new fuel sender. Align mark made during disassembly. Tighten lock ring until it contact stops.
23.
Connect fuel sender electrical connector.
24.
Raise fuel tank enough to connect fuel lines.
25.
Connect fuel supply, return and vapor lines.
26.
Install fuel filler pipe in fuel tank.
27.
Position fuel tank in installed position.
28.
Install fuel tank straps. Tighten retaining bolts to 30-40 Nm (22-30 lb/ft).
29.
Remove adjustable jack.
30.
Connect fuel pump electrical connector.
31.
Install fuel filler pipe rubber weather boot to inner fender well.
32.
Install screw retaining fuel filler pipe retainer to fuel tank flange. Tighten screw to 7.3-9.0 Nm (65-80 lb/in).
33.
Lower vehicle.
34.
Install fuel filler pipe retainers to gas cap side of fuel filler pipe.
35.
Fill fuel tank.
36.
Connect battery negative cable, then remove memory saver.
37.
Start and run engine.
38.
Raise vehicle.
39.
Inspect fuel system for leaks.
40.
Lower vehicle.
Taurus/Sable
1.
Install memory saver, then disconnect battery negative cable.
2.
Remove fuel system pressure as follows:
^
Remove schrader valve cap and attach EFI/CFI fuel pressure gauge.
^
Slowly open manual valve on fuel pressure gauge to relieve fuel system pressure.
3.
Completely drain fuel tank. It may be necessary to disconnect fuel filler hose to drain fuel tank.
4.
Raise and support vehicle.
